Adjusting The Position Of The Mirror - Oce 3121 Technical & Service Manual

5 Adjusting the position of the mirror

(the optical length of the mirror No. 1, No. 2 and No. 3)
Prepare the positioning tool.
1
mirror' on page
Move the mirror support No. 1 forwards until the hole in the side plate and the
2
hole in the slide for the mirror support No. 1 are in line and, also, the holes for
the mirror support No. 2.(Do the same for the rear side plate.)
Fit the positioning tool to the mirror support No. 1 and to the mirror support
3
No. 2.(Both front and rear).
For rear
Mirror supports No. 2 & 3
Tighten the set screw of the pulley.
4
Remove the tools.
5
406 TSM Océ 3121
see 'Preparing the tool for the positioning of the
405.
Mirror support No. 1
For front
Dis-/assembly