Adjusting The Transport Distance - Oce 3121 Technical & Service Manual

9 Adjusting the transport distance

Adjust the transport distance only after adjusting the parallel transport
Note:
1 and the parallel transport 2.
Copier mode
Shift bits 1 and 4 to ON: DIP switch (DSW1) on the RDF control PBA.
1
Place a sheet of A3 or 11"x 17" paper (80 g/m2) on the document tray.
2
Press once on the switch (SW3) on the RDF control PBA.
3
The paper will be picked up, and stopped on the platen.
I
Open the RDF slowly, and measure the document stop position l4; then, close
4
the RDF slowly.
platen
L4
ed.1
document
Standards:
Stop position L4 = 11.6 ± 1mm
10 RDF 311