Adjusting The Rdf Switch (Ms1) - Oce 3121 Technical & Service Manual

Adjustments

1 Adjusting the RDF Switch (MS1)

Two micro-switches are fitted. These prevent operation of the RDF when
Note:
either the body is opened, or the upper cover is opened. MS1 monitors the
body, MS2 monitors the upper cover.
As a rule, skip the following adjustment; make adjustments only when neces-
sary.
Remove the cover.
1
Open and close the RDF. Adjust the retaining plate (2), until switch MS1 (1)
2
switches on and off when the lower edge of the RDF is between 10 and 100
mm from the platen.
10 ~ 100 mm
ed.1
(1)
(2)
RDF
Copier
10 RDF 301