Installation Of The Fax - Oce 3121 Technical & Service Manual

9 Installation of the Fax

INSTALLATION
Preparation
The Basic Expansion Kit is required.
1
If the Basic Expansion Kit is already installed, remove its component units be-
2
fore starting.
Ensure that the mains supply cable is disconnected before starting.
3
If a PBA other than the FAX PBA is fitted in the Base Unit, first remove that
4
PBA before installing the FAX PBA..
If the Printer PBA is fitted, cut the cable tie (as shown in the figure), and re-
5
move the CORE PBA from the Base Unit.
(Be sure to use the new cable tie when refitting the CORE PBA.)
Ensure that the copier has been properly installed.
1
Ensure that the mains supply cable is disconnected before starting the instal-
2
lation.
Identify the screws by type (length, diameter, location).
3
Some screws come with a washer to protect against static electricity. Ensure
4
that these are used.
The installation should proceed in the following sequence:
Speaker
1
Setting the Bits on the NCU PBA
2
Modular Unit
3
Base Unit
4
CORE PBA
5
Modular Unit Harness
6
FAX PBA, Earth Cable, Harness, Cover
7
Making Settings (line, NL, transmission level, etc.)
8
ed.1 Installation 55