Stapler Alarm (Multi Tray-12) - Oce 3121 Technical & Service Manual

Stapler alarm (Multi Tray-12)

Code Nature Cause
02H Staple jam The stapler safety sen-
sor MS6 has turned on
for some reason.
The stapler is not
securely installed.
Normal stapling oper-
ation is not possible.
03H Stapling The stapler safety sen-
safety pro- sor MS6 has turned on
tection during stapling opera-
mecha- tion.
nism acti-
vation
05H Over sta- The volume of paper
pling in a single bin has
capacity exceeded the maxi-
mum value (20 sheets)
in stapler sorter mode.
06H Full sta- The volume of paper
pling in a single bin has
capacity. reached the maxi-
mum value (20 sheets)
in stapler sorter mode.
07H Mixed Sheets of different
paper widths have been
sizes placed in the bin.
09H Paper in Paper is remaining
bin. inside the bin
0AH Staple The stapler has run
absent. out of staples.
ed.1
Operation Display
Stops stapling Flashes the
Manual Sta-
ple key.
Indicates a
message on
the copier's
control
panel.
Stops sta- No indica-
pling. tion
Finishes sort- Indicates a
ing but stops message on
without sta- the copier's
pling. control
panel.
Operates nor- No indica-
mally. tion
Finishes sort- No indica-
ing but stops tion.
without sta-
pling.
Indicates a Turns on the
message if the Manual Sta-
stapler sorter ple key.
mode is Indicates a
selected. message on
the copier's
control
panel if the
stapler sorter
mode is
selected in
this condi-
tion.
Prohibits sta- Indicates the
pling. Add Staple
message.
Resetting
Wait until the
machine automati-
cally recovers
(about 1 sec after the
stapler safety sensor
turns off).
Open and then close
the stapler cover.
Remove the cause
that turned on the
stapler safety sensor
MS6; wait until the
machine recovers
automatically in
about 1 sec after the
stapler safety sensor
turns off.
Remove all paper
(stack).
Remove all paper
(stack).
Remove all paper
(stack).
Remove all paper
(stack).
Replace the staple
cartridge.
SDS Description 13