Making Adjustments - Oce 3121 Technical & Service Manual

Making Adjustments

Start service mode.
1
Select the appropriate item.
2
Press the appropriate item to highlight.
I
Place copy paper on the RF's original tray as follows:
3
In the case of 'DOC_ST_T' or 'DOC_ST_B, place one A3 sheet of copy pa-
I
per.
In the case of 'P_INTRVL_T' or 'P_INTRVL_B', place two A4 sheets of
I
copy paper.
Enter a setting on the keypad.
4
In the case of 'DOC_ST_T' or 'DOC_ST_B',
I
A higher setting will result in a shift to the trailing edge.
A lower setting will result in a shift to the leading edge.
In the case of 'P_INTRVL_T' or 'P_INTRVL_B',
I
A higher setting will increase the sheet-to-sheet distance.
A lower setting will decrease the sheet-to-sheet distance.
Press the OK key.
5
The sheet on the original tray will be picked up and stopped on the copyboard
I
glass.
Open the RF slowly, and check where the paper has been stopped.Thereafter,
6
close the RF without removing the paper. (See below for standards.)
Press the OK key.
7
The sheet on the copyboard glass will be discharged to the RF's original tray.
I
(However, in the case of 'DOC-STP-T' and 'P_INTRVL_T', the sheet will
be discharged to the RF's original delivery tray.)
To end the work, press the Reset key twice to leave service mode.
8
ed.1 SDS Description 73