Using Adjustment Mode And Settings Mode - Oce 3121 Technical & Service Manual

Using Adjustment Mode and Settings Mode

In adjustment mode (*3*; ADJUST) and in settings mode (*5*; OPTION), the
settings changed/selected on the control panel are stored in RAM on the image
processor PCB and operation/control is executed according to the settings.
(These settings will be stored permanently when the main power switch is
turned off and on after execution.
The factory default settings of adjustment mode (*3*; ADJUST) are recorded
in the service-label. Be sure to record any new settings if you made changes in
the field. Further, you must enter the settings recorded on the label whenever
you have cleared the RAM.
If you replaced the image processor PCB or the composite power supply PCB,
be sure to enter the settings recorded on the respective label. (You need not do
so when you have replaced only the ROM.)
MF-A6R
MF-A4R
MF-A4
PRI DC (IMG)
PRI DC(on IMG)
DVLP DC (IMG)
DVLP DC (on
IMG)
TRNS (IMG)
TRNS(on IMG)
PRI AC (IMG)
PRI AC(no IMG)
AGS GAIN
AGS OFST
PRI DC OFST
PRI AC OFST1
PRI AC OFST2
TRNS OFST
FL OFST
Service Label; attached behind the front door
4 TSM Océ 3121
DVLP DC OFST
H-ADJ
V-ADJ
REGIST
RSIDE-SENSHP
PVE-OFST
IC-DENS
CST-LOOP
MF-LOOP
DENS-ADJ
ADJ-S
LASER OFF
PWN 600 MIN
PWN 600 MAX
PWN 200 MIN
PWN 200 MAX
AE-SLOP
FIXER_RESIST
FILM LANK
ABC_TBL
STRD_ADJ
PPR
W-PLT
TRNS_1
TRNS_2TS
TRNS_2OL
SDS Description