Clearing The Configuration; Switch Settings - Compaq ProLiant 5000 Reference Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Clearing the Configuration

CAUTION:
clear the contents of the EISA non-volatile memory when troubleshooting.
Doing so may cause you to lose information.
To clear the computer configuration, you must set switch 6 on the system
board to the ON position. Then cold boot the server (turn the power switch
off, then back on). When you turn on this switch, also called the System
Configuration Maintenance switch, you clear the configuration from non-
volatile memory. The computer must then be reconfigured with switch 6 in
the OFF position.
CAUTION:
IMPORTANT:
option, you can also select System Configuration / Configuration Backup / Restore
from a System Configuration .SCI File.

Switch Settings

S6 = ON Erases, or clears the current System Configuration
S6 = OFF (default) Uses the current System Configuration
To clear then reset the computer configuration, complete the following steps:
1. Turn OFF the server.
2. Remove the side access panel (cover on rack models).
3. Set switch 6 to the ON position.
Writer: Project: Using the Compaq System Configuration Utility Comments:
Do not use the System Configuration Maintenance switch to
Be certain the power is turned OFF before you move switch 6.
In addition to the System Configuration and Configure Hardware
File Name: J-ch6.doc Last Saved On: 4/18/97 6:43 PM
Compaq ProLiant 5000 Servers Reference Guide
6-17