Compaq ProLiant 5000 Reference Manual page 12

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
xxii Preface
Chapter 7 − − NETWORK INTERFACE CONTROLLERS
This chapter describes the features and advantages of the Compaq
10/100 TX PCI UTP Board, standard on ProLiant 5000 servers, and
other Compaq controllers available as options.
Chapter 8 − FAST-WIDE SCSI-2 SUBSYSTEM
This section includes information about the integrated SCSI device
controller, multiple-controller installations, configuration and planning.
Chapter 9 − − COMPAQ SMART-2 ARRAY CONTROLLER
The newest Compaq array controller, standard in some models of the
ProLiant 5000, is discussed here.
Chapter 10 − − SERVER MANAGEMENT
This chapter describes server management features that include fault
tolerance, performance and configuration of servers. Remote server
management is explained.
Chapter 11 − − DIAGNOSTIC TOOLS
This chapter describes software and firmware diagnostic tools available
for ProLiant users, including POST, DIAGS, DAAD, flash ROMs
and ASR-2.
Chapter 12 − − SECURITY
Various hardware and software features Compaq built into ProLiant
servers for multi-level security control are discussed in this chapter.
Chapter 13 − − MAINTENANCE AND SAFETY PRECAUTIONS
This section contains information on troubleshooting, system care and
maintenance of the server, and safety precautions.
Appendix A − − USING THE INTERNAL CD-ROM DRIVE
The CD-ROM drive installed in ProLiant servers is used in the
configuration. This appendix provides operating instructions and
precautions for use and transportation.
Appendix B − − POWER CORD SET REQUIREMENTS
This appendix contains requirements for the power cord set now
available with the Compaq ProLiant servers (tower only). In addition to
this information, a table is provided with power cord set requirement
information for each country.
Writer: Compaq Project: Preface Comments: Final Review
File Name: D-prefac.doc Last Saved On: 4/18/97 5:02 PM