Compaq ProLiant 5000 Reference Manual page 234

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Appendix C
Electrostatic Discharge
To prevent damaging the system, follow these precautions when setting up the
system or handling parts. A discharge of static electricity from a finger or
other conductor may damage system boards or other static-sensitive devices.
This type of damage may reduce the life expectancy of the device.
To prevent electrostatic damage, observe the following precautions:
Avoid hand contact by transporting and storing products in static-safe
containers.
Place parts on a grounded surface before removing them from their
containers.
Avoid touching pins, leads, or circuitry.
Always be properly grounded when touching a static-sensitive
component or assembly.
Grounding Methods
There are several methods for grounding. Use one or more of the following
measures when handling or installing electrostatic-sensitive parts:
Use a wrist strap connected by a ground cord to a grounded
workstation or computer chassis. Wrist straps are flexible straps with a
minimum of 1 megohm +/- 10 percent resistance in the ground cords.
To provide proper ground, wear the strap snug against the skin.
Use heelstraps, toestraps, or bootstraps at standing workstations. Wear
the straps on both feet when standing on conductive floors or
dissipating floor mats.
Use conductive field service tools.
Use a portable field service kit with a folding static-dissipating work
mat.
If you do not have any of the suggested equipment for proper grounding, have
an Authorized Compaq Reseller install the part.
For more information on static electricity or assistance with product
installation, contact your Authorized Compaq Reseller.
Writer: Project: Appendix C Comments:
File Name: T-appc.doc Last Saved On: 4/22/97 1:21 PM
Compaq ProLiant 5000 Servers Reference Guide
C-1