Installing Dimms - Compaq ProLiant 5000 Reference Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installing DIMMs

CAUTION:
Be sure you are properly grounded before beginning any installation
procedure. Refer to Appendix C, "Electrostatic Discharge," for more
information.
To install a memory module, complete the following steps:
1. Remove the "Y" bracket
Figure 2-10. Removing the "Y" bracket
2. Remove both memory boards from the I/O board and place them flat
on a static-dissipating work surface.
3. Align the key slot in the bottom edge of each DIMM with the tab in the
expansion slot. DIMMs will not seat if turned the wrong way.
Writer: Compaq Project: Installing the Compaq ProLiant 5000 Server Comments:
Electrostatic discharge can damage electronic components.
File Name: F-ch2.doc Last Saved On: 4/18/97 5:09 PM
Compaq ProLiant 5000 Servers Reference Guide
2-15