Compaq ProLiant 5000 Reference Manual page 156

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
10-22 Server Management
Option
Network status
Network
protocol
Network
controller
Table 10-5
Compaq System Configuration Utility
Remote Option Settings for Booting into Compaq Utilities
Setting
Enabled
Compaq
Writer: Project: Server Management Comments:
File Name: N-ch10.doc Last Saved On: 4/23/96 11:31 AM
Description
To allow network access to Compaq Utilities, set
Network Status to Enabled and make sure the
Reset Boot option is set to Boot Compaq Utilities.
To use IPX network access, set Network Protocol
to IPX. When the system restarts to the Compaq
Utilities because of an ASR reset, it will load IPX
network support. This will enable remote access
via NVT.
To use IP network access, set Network protocol
to IP. Also make sure to set Network IP address,
Network IP net mask and Network IP router
address. When the system restarts to the
Compaq Utilities because of an ASR reset, it will
load IP network support. This will enable remote
access via Telnet.
NOTE: The Network Status must be set to
Enabled for network access.
Select the network controller type - choices are
Compaq and Custom. Select Compaq for the
NetFlex-2 ENET-TR Controller and the
NetFlex-TR Controller.
continued