Compaq ProLiant 5000 Reference Manual page 92

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing Processor Power Modules
The Processor Power Module is keyed to ensure correct alignment. A notch in
the bottom edge of the module, near the center, must align with a tab in the
mounting bracket. The notch and tab will not line up if the module is turned
the wrong way.
Follow these steps to install a Processor Power Module:
1. With the module a 45-degree angle, align the connectors.
2. Gently rotate the module upright until it snaps into place. This requires
light pressure.
Figure 5-8.
Removing Processor Power Modules
Follow these steps to remove a module:
1. Spread the silver locking tabs on each end of the module.
2. Tip the module forward and extract it from the socket. This requires
light pressure.
Writer: Compaq Project: Special Features of Compaq ProLiant 5000 Servers Comments:
Installing a Processor Power module
File Name: I-ch5.doc Last Saved On: 4/18/97 6:33 PM
Compaq ProLiant 5000 Servers Reference Guide
5-7