Compaq ProLiant 5000 Reference Manual page 170

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
POST Error Messages
Error Code
605-Diskette Drive
Type Error
702-A coprocessor
has been detected
that was not reported
by CMOS.
703-CMOS reports a
coprocessor that has
not been detected
1151-Com Port 1
Address Assignment
Conflict
1152-Com Port 2, 3,
or 4 Address
Assignment Conflict
1600-Server
Manager/R Failure
1613-Low System
Battery
1610-Temperature
violation detected.
Waiting for system to
cool
1611-Fan failure
detected
* L= Long
S = Short
Continued
Audible
Beeps*
2S Mismatch in drive type
None Installed coprocessor not
configured.
2S Coprocessor or
configuration error.
2S Both external and internal
serial ports are assigned
to COM1.
2S Both external and internal
serial ports are assigned
to COM2, COM3 or COM4.
None Server Manager/R board
failure. Error code displays
after error message.
None Real time clock system
battery is running low on
power.
2S Ambient system
temperature too hot.
2S Required fan not installed
or spinning.
Writer: Project: Diagnostic Tools Comments:
File Name: O-ch11.doc Last Saved On: 4/22/97 1:11 PM
Probable Source of
Problem
Run the System
Configuration Utility to
set diskette type
correctly.
Run the System
Configuration Utility
and correct.
Run the System
Configuration Utility
and correct
Run the System
Configuration Utility
and correct.
Run the System
Configuration Utility
and correct.
Run Diagnostics.
Contact your service
provider
Run Diagnostics.
Contact your service
provider.
Check fan in system
environment.
Check fans.
Compaq ProLiant 5000 Servers Reference Guide
11-7
Action
continued