Drive Installation Guidelines - Compaq ProLiant 5000 Reference Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Drive Installation Guidelines

The following guidelines should be noted when adding SCSI hard drives:
A maximum of seven SCSI-2 devices may be added per controller.
The SCSI ID for each hot-pluggable hard drive is set as shown in
Figure 2-17.
If only one SCSI hard drive is used it should be installed in the
lowest bay.
Compaq SCSI cables for the Compaq ProLiant 5000 are terminated. Be
sure to remove all terminating jumpers from third-party SCSI devices.
NOTE :
IMPORTANT:
pluggable hard drives to the controller.
Figure 2-17.
Writer: Compaq Project: Installing the Compaq ProLiant 5000 Server Comments:
Supported Compaq SCSI options are not terminated.
When adding a Compaq SMART-2 Array Controller, attach only hot-
Assigned SCSI IDs
File Name: F-ch2.doc Last Saved On: 4/18/97 5:09 PM
Compaq ProLiant 5000 Servers Reference Guide
2-21