Ricoh MP C6502SP System Maintenance page 813

Hide thumbs Also See for MP C6502SP:

Table of Contents

009 Bit Switch 9 Settings

PDL Auto Detection timeout of jobs submitted via

USB or Parallel Port (IEEE 1284).

To be used if PDL auto-detection fails. A failure of PDL auto-detection doesn't

necessarily mean that the job can't be printed. This bit switch tells the device whether

to time-out immediately (default) upon failure or to wait 10 seconds.

If this bit switch, all jobs will be cancelled after a jam occurs.

Note: If this bitsw is enabled, printing under the following conditions might result in

- Job submission via USB or Parallel Port

- Spool printing (WIM >Configuration > Device Settings > System)

PCL/PS bypass tray paper rotation (SEF/LEF)

This bitsw causes the device to revert to the behavior of previous generations. It only

takes effect if "Bypass Tray Setting Priority" = "Driver/Command".

Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the bypass

tray, the MFP always prompted for SEF paper.

If this bitsw=0 (default) then in the event of a standard sized paper mismatch, the

MFP will always prompt for paper of the rotation (SEF/LEF) determined by the MFP

bypass tray paper setting or by the bypass tray sensor.

Timing of the PJL Status ReadBack (JOB END) when

printing multiple collated copies.

This switch determines the timing of the PJL USTATUS JOB END sent when multiple

collated copies are being printed.

0 (default): JOB END is sent by the device to the client after the first copy has

completed printing. This causes the page counter to be incremented after the first

copy and then again at the end of the job.

1: JOB END is sent by the device to the client after the last copy has finished printing.

This causes the page counter to be incremented at the end of each job.

(10 seconds)

Show Quick Links

Table of Contents