Ricoh MP C6502SP System Maintenance page 317

Hide thumbs Also See for MP C6502SP:

Table of Contents

Connection Timing Adjustment

When the Call Center calls out to an embedded RCG-M modem, it sends a repeating ID

tone (*#1#). This SP sets the time the line remains open to send these ID tones after the

number of the embedded RCG-M modem is dialed up and connected.

The actual amount of time is this setting x 2 sec. For example, if you set "2" the line will

remain open for 4 sec.

Access Point

This is the number of the dial-up access point for RCG-M. If no setting is done for this SP

code, then a preset value (determined by the country selected) is used.

Allowed: Up to 16 alphanumeric characters

Line Connecting

This SP sets the connection conditions for the customer. This setting dedicates the line to

RCG-M only, or sets the line for sharing between RCG-M and a fax unit.

• If this setting is changed, the copier must be cycled off and on.

• SP5816 187 determines whether the off-hook button can be used to interrupt a RCG-

M transmission in progress to open the line for fax transaction.

Modem Serial No.

This SP displays the serial number registered for the RCG-M.

Retransmission Ringing

Normally, it is best to allow unlimited time for certification and ID2 update requests, and

for the notification that the certification has been completed. However, RCG-M generates

charges based on transmission time for the customer, so a limit is placed upon the time

allowed for these transactions.

If these transactions cannot be completed within the allowed time, do this SP to cancel the

time restriction.

[0 to 24 / 1 / 1/step]

up to 16 char.

[0 to 1 / 0 / 1/step]

0: Sharing Fax

1: No Sharing Fax

SP5-722 to 998 (Mode)

Show Quick Links

Table of Contents