Raytheon Pathfinder ECDIS Operator's Manual page 88

4.4 DIGITIZATION (OPTION)
Following overlapping functionalities are possible in combination with the
ECDIS Chart Digitization Calcomp Drawing Board III:
• Route Planning
Using the puck at the Chart Digitization Station, the desired waypoints of a
route are marked on the paper sea chart, transmitted to the ECDIS and (route
processing see chapter 8.2.).
• Drawing Objects
Using the puck at the Chart Digitization Station, this function allows the user to
mark object coordinates (anchoring grounds, fishing grounds etc.) on the paper
sea chart and have them displayed on the ECDIS (Drawing Tool see chapter
10.1).
Procedure: (see Figure: 4−8)
Step 1 Select Chart Description .... (see chapter 4.4.1)
Step 2 Select Select Chart ...
Step 3 Before you start with Route Planning or Drawing objects, you must
Step 4 Select the object button Existing Alignment for Route Planning
3655DOC020102
Operator Manual
select the object button Enter New Alignment.
After this procedure the window closes−up.
then start with Step 2 again
or Existing Alignment for Drawing objects
.
4−16
Edition: 30.MAR.2007