Raytheon Pathfinder ECDIS Operator's Manual page 287

9.1.2 Rhumb/Great Circle Line
Within this NavTool it is possible to calculated distances of two positions on a
Rhumb Line or a Great Circle Line.
Procedure: (see Figure: 1−4)
Step 1 Select Rhumb/Great Circle Line from the Nav Tools menu.
Step 2 Position the cursor at the first point of interest, read out the cursor
Step 3 Position the cursor at the second point of interest, read out the cursor
Step 4 By selection of Show Rhumb Line or Show Great Circle Line by
Step 5 Click on the Close button.
Edition: 30.MAR.2007
ECDIS
Operator Manual
The dialog box appears.
position (status bar). Edit the cursor position value into the
Start Coordinates field. To change the field, press the [Tab] button
from the keyboard.
position (status bar). Edit the cursor position value into the
End Coordinates field.
marking in the check box the lines are faded in.
The Rhumb or Great Circle Line disappears .
9−5
R
Raytheon Anschütz GmbH
Germany
3655DOC020102