Raytheon Pathfinder ECDIS Operator's Manual page 263

8.2.11 Sending and Displaying ECDIS objects and Route on the Radar
ECDIS allows you to send and display objects on selected radars.
ECDIS is compatible with any device whose I/O ports are according to designed
NMEA 0183.
When integrating a radar which will accept data from ECDIS, it must not share a
COM port with any other navigation device. This also applies to the autopilot.
Because of the "exclusive or" drawing routine used by the radar, any
object which is sent to the radar twice (or an even number of times) will
not be visible.
8.2.11.1 Send to Radar
Procedure: (see Figure: 1−27)
Step 1 Click with the [Query] button on the object you want to send to your
The object information is sent to the radar. If the Send to Radar
command in not enabled, please check to make sure that the radar is
the active radar in the ARPA Radar Tracking dialog box (Radar
Tracking ON). Please see Integrating an ARPA Radar, see chapter
12.1.4.
Edition: 30.MAR.2007
ECDIS
Operator Manual
radar (e.g. Depth contour);
then press Send to Radar from the dialog box which appears.
8−35
NOTE
NOTE
R
Raytheon Anschütz GmbH
Germany
3655DOC020102