Raytheon Pathfinder ECDIS Operator's Manual page 249

Step 4 Select Change next to the datum list box and scroll through the pull−
Step 5 To enter the latitude and longitude of a waypoint, type in the
Step 6 Label the waypoint by typing a label of up to 10 characters in the
Step 7 Enter a turn radius for the waypoint by clicking in the Radius text box
Step 8 Click on Convert to convert the waypoint's datum into WGS1984 da−
Step 9
Step 10
Step 11
Step 12
Edition: 30.MAR.2007
ECDIS
Operator Manual
down to select the datum of the chart from which you read off the
waypoint (see Figure: 1−13)
hemisphere, degrees and minutes. If you express minutes to a tenth,
hundredth or thousandth of a minute, be sure to include a decimal
point (.).
Label text box.
and entering the desired value.
tum. The converted coordinates appear in the Edit Route dialog box
Waypoint coordinates from the paper chart with different datum
((not WGS 84) (see chapter 8.2.1.5)).
In this case read off the datum from paper chart. Click on Change and
select the corresponding datum from the opening datum list.
Enter waypoint coordinates in the Latitude/Longitude fields, and click
on Convert. The coordinates will be converted and filled automatically
in the Lat/Lon of the waypoint group.
Click on Accept. The waypoint appears in the waypoint list, and
a waypoint symbol appears in the display.
To enter additional waypoints, repeat steps 2 − 9. A waypoint
symbol appears at each location you specify and the route is
extended with fairlanes and a planned track (dashed).
To enter a cross−track error, click in the XTD text box and enter the
cross−track limit in m. Click on Set to make the change.
The fairlanes on the display will be adjusted according to the
cross−track limit settings.
Click on Quit. The Save Route dialog box appears.
To save the route, type a name of up to 25 characters in the text
box, then click on OK. If you do not want to save the route, click on
Cancel.
8−21
R
Raytheon Anschütz GmbH
Germany
3655DOC020102