Raytheon Pathfinder ECDIS Operator's Manual page 242

boxes.
Step 1.1 To extend the route, either enter waypoints in the display per
Step 1.2 Select the OK button, if the a route extending is finished.
Step 1.3 To save the route using the same name, click on OK. If you want to
(2)
You can change a waypoint's location either by moving it in the display or by
using the Latitude and Longitude boxes to specify new coordinates.
Step 2.1 Using the target cursor
3655DOC020102
Operator Manual
cursor, or specify their coordinates in the Latitude and Longitude
boxes.
The Save Route dialogue box appears displaying the name of the
route.
save the route using a new name of up to 25 characters, then click on
OK. If you do not want to save your changes, click on Cancel.
Option button Route: Change selected (see Figure: 1−10)
Position the cursor over the desired waypoint and click the Enter key.
Position the cursor at the Waypoints new location and click the
Enter key again. The waypoint is repositioned in the display and the
route is redrawn. The Waypoints new coordinates are displayed in
the Waypoint list box.
or Using waypoint list in the dialog box
Click on the desired waypoint.
Enter new coordinates for the waypoint in the Latitude and Longitude
boxes.
Click on Accept. The waypoint is repositioned in the display and the
route is redrawn. The Waypoints new coordinates are displayed in
the Waypoint list box.
Datum is always WGS 1984.
NOTE
8−14
Edition: 30.MAR.2007