Sending Scan File By Scan To Ftp; Selecting An Ftp Server - Ricoh Network Scanning Unit A Operating Instructions Manual

Sending Scan File by Scan to FTP

Selecting an FTP Server

You can select a single FTP server as a
destination to which you send a
scanned file. Follow the steps below
to select an FTP server.
A A A A
Press the { { { { 1} } } } key.
Note
❒ You can skip this step when the
E - m a i l / S e n d F i l e s t a n d b y
screen is displayed.
The E-mail/Send File standby
screen is displayed.
B B B B
Press [SMB/FTP].
7
C C C C
Press the { { { { 1 1 1 1 } } } } or { { { { 0 0 0 0 } } } } key to high-
light [FTP], and then press [List].
The list of the FTP servers that are
registered to this machine appears.
D D D D
Use [↓ ↓ ↓ ↓ Next] or [↑ ↑ ↑ ↑ Prev.] to scroll
through the pages, and display
the FTP server name you wish to
select.
142
To recall FTP servers using a title
A Press the { { { { ./*} } } } (Title) key.
A list of titles appears on the
screen.
Note
❒ Titles are displayed accord-
ing to the settings in [Configu-
ration] → [Basic Settings] →
[Scanner] → [Select Title] on
the Web Status Monitor.
B Use the { { { { 1 1 1 1 } } } } or { { { { 0 0 0 0 } } } } key to
highlight the title you wish to
select, and then press [OK].
The FTP servers assigned to the
selected title are displayed.
Note
❒ You can select the title under
which each of the registered
destinations is assigned in
[Configuration] → [E-mail Set-
tings] → [E-mail Address] →
[Assign Title] on the Web Sta-
tus Monitor.
To recall all available destinations
A Press the { { { { ./*} } } } (Title) key.
A list of titles appears on the
screen.
B Use the { { { { 1 1 1 1 } } } } or { { { { 0 0 0 0 } } } } key to
highlight [All], and then press
[OK].