Performing Scan Operation; Starting A Scan Operation; To Start With Originals On The Adf - Ricoh Network Scanning Unit A Operating Instructions Manual

Performing Scan Operation

Starting a Scan Operation

To start with originals on the ADF

A A A A
Confirm that the E-mail Ready
screen is displayed.
W h e n "
S e l e c t
" is displayed, no desti-
tion(s).
n a t i o n i s s e l e c t e d . S e l e c t a
destination to display "
the screen.
B B B B
Press the { { { { Start} } } } key of this ma-
chine.
Scanning originals starts on the
ADF of the scanner connected to
this machine.
Note
❒ To interrupt scanning, press the
{ { { { Clear/Stop} } } } key.
❒ When "
Show Options after
Each Scan Job
[End of Scan Option] under
[2.Send Scan Settings], a screen
for selecting the next operation
appears after scanning of all the
originals on the ADF of the
scanner is completed.
• Press [Add] to continue scan-
ning by adding the scanned
data to the current image file.
d e s t i n a -
" on
Ready
AHQ004S
" is selected for
Performing Scan Operation
• Press [New Job] to finish the
current scanning job and
send the scanned data. You
can start a new job with the
current settings after the
scanned data is sent.
• Press [OK] to finish the cur-
rent scanning job, send the
scanned data, and then re-
turn to the initial screen at
the time when the power has
been turned on.
If you do not press any key,
this machine acts as if [OK]
has been pressed, after the
specified period.
When scanning finishes properly,
the e-mail is sent to the E-mail
(SMTP) Server. The "B" appears
at the upper right corner of the
screen while the e-mail is sent.
Note
❒ You cannot perform any opera-
tions while the "B" is dis-
played on the screen.
❒ Do not turn off the power of this
machine while the "B" is dis-
played on the screen.
The "B" disappears when the e-
mail has been sent to the E-mail
( S M T P ) S e r v e r , a n d t h e E -
mail/Send File standby screen ap-
pears.
5
127