To Start With An Original On The Exposure Glass - Ricoh Network Scanning Unit A Operating Instructions Manual

Sending Scan File by E-mail
To start with an original on the exposure
glass
A A A A
Confirm that the E-mail Ready
screen is displayed.
W h e n "
tion(s).
n a t i o n i s s e l e c t e d . S e l e c t a
destination to display "
the screen.
B B B B
Press the { { { { Start} } } } key of this ma-
5
chine.
Scanning an original on the expo-
sure glass of the scanner starts.
Note
❒ To interrupt scanning, press the
{ { { { Clear/Stop} } } } key of this machine.
After the original is scanned prop-
erly, the message "
original(s) and press the
Start key, or press [Finish]
to complete.
C C C C
Place the next original on the ex-
posure glass of the scanner, and
then press the { { { { Start} } } } key of this
machine.
D D D D
Repeat the step
128
S e l e c t d e s t i n a -
" is displayed, no desti-
Ready
Set the next
" appears.
C C C C
as necessary.
E E E E
Press [Finish] when all the origi-
nals are scanned.
Note
❒ When "
Each Scan Job
[End of Scan Option] under
[2.Send Scan Settings], a screen
for selecting the next operation
appears after you press [Finish].
When scanning finishes properly,
the e-mail is sent to the E-mail
(SMTP) Server. The "B" appears
at the upper right corner of the
" on
screen while the e-mail is sent.
Note
❒ You cannot perform any opera-
tions while the "B" is dis-
played on the screen.
AHQ004S
❒ Do not turn off the power of this
machine while the "B" is dis-
played on the screen.
The "B" disappears when the e-
mail has been sent to the E-mail
( S M T P ) S e r v e r , a n d t h e E -
mail/Send File standby screen ap-
pears.
Show Options after
" is selected for