Advertisement
<Work procedure 1-7>
8) Remove the fixing / feed cover (lower).
- 2 screws
9) Remove the fixing main unit.
- 1 connector
- 2 wire saddles
- 1 edge saddle
- 1 stepped screw
10) Check the 2 Shaft Support Members [1] on the host machine side and the 2 pins [2] of the Positioning
Plate of the Fixing Assembly for any abnormality.
11) If abnormality is found, replace the faulty part.
12) Install the removed parts in reverse order.
13 / 13
Advertisement
