Advertisement
< Work procedure 1-2>
Check the Shaft Support Members for any damage: Secondary Transfer Unit [E-1]
1) Open the Front Left Cover and the Front Right Cover.
2) Pull Out Fixing Feed Unit.
3) Remove the Secondary Transfer Outer Unit.
4) Check the 4 Positioning Pins [1] of the Secondary Transfer Outer Unit for any abnormality.
5) If abnormality is found, replace the faulty part.
6) Install the removed parts in reverse order.
Check the Shaft Support Members for any damage: Frame body of the ITB Unit [E-1]
1) Open the Front Left Cover and the Front Right Cover.
2) Remove Process Unit Cover.
3) Pull Out ITB Unit.
CAUTION:
Be sure to pull out the Fixing Feed Unit and ITB Unit to the position where latch is locked.
Reason: Disengagement between the Positioning Pin of the Secondary Transfer Outer Unit and Shaft
Support Member of the frame body of the ITB Unit becomes insufficient, and it may cause damage when
assembling the Intermediate Transfer Belt Unit.
4) Remove ITB Cleaning Unit.
7 / 19
Advertisement
