Advertisement
18) When abnormality is found in the installation of the 2 Pressure Springs [1] of the Primary Transfer Roller
such as being bent or not properly put on the mount of the spring, correct the deformation of the springs
or their installation.
19) If abnormality is not solved, replace the faulty part.
20) Install the removed parts in reverse order.
CAUTION:
Make sure to avoid the edge of the ITB displacement sensor lever from overlapping with the ITB at
installation.
CAUTION: After assembly, execute ITB position adjustment in service mode.
(ITB position adjustment: COPIER > FUNCTION > INSTALL > INIT-ITB)
< Work procedure 1-4>
7 / 12
Advertisement
