Advertisement
9) Remove the Drum Drive Unit.
-11 Screws (black TP)
CAUTION:
When removing the Drum Drive Unit, be sure not to damage (bend) the High Voltage Cable since it can be
easily disconnected.
Be sure to free the High Voltage Cable from the Edge Saddle after pulling out the Drum Drive Unit a little.
10) Lift the Drum Shaft Unit, and remove it from the host machine.
- 3 Screws
CAUTION:
When installing the Drum Shaft Unit and the Drum Drive Unit to the host machine, do not remove the 4
screws [1] securing the Process Unit on the front side of the machine.
<Work procedure 2-12>
5 / 13
FRONT
Advertisement
