Advertisement
<Work procedure 2-12>
16) Install the Drum Drive Unit [1].
・11 Screws [2]
Points to Note when Installing the Drum Drive Unit:
- Install the unit with the boss [1] at the center of the boss hole [2].
- Tighten the 11 screws in the order from 1 to 11 shown in the figure below.
- Be sure that the Static Eliminator [3] is in contact with only the upper side of the Drum Shaft. (The Static
Eliminator should not be on the lower side of the Drum Shaft.)
CAUTION:
Points to Note after Installing the Drum Drive Unit
- Wipe grease off the Static Eliminator with lint-free paper moistened with alcohol.
Grease can be easily removed by rotating the shaft clockwise with the lint-free paper gently pressed against
the Static Eliminator as shown in the figure below.
8 / 13
Advertisement
