Advertisement
Check the Shaft Support Members for any damage: Frame body of the ITB Unit [D-1]
1) Open the Front Left Cover and the Front Right Cover.
2) Remove Process Unit Cover.
3) Pull Out ITB Unit.
CAUTION:
Be sure to pull out the Fixing Feed Unit and ITB Unit to the position where latch is locked.
Reason: Disengagement between the Positioning Pin of the Secondary Transfer Outer Unit and Shaft
Support Member of the frame body of the ITB Unit becomes insufficient, and it may cause damage when
assembling the Intermediate Transfer Belt Unit.
4) Remove ITB Cleaning Unit.
5) Hold the grip and with opening the intermediate transfer belt unit, remove the support shaft.
6) Open the intermediate transfer belt unit by approx. 90 degree, align the end of support shaft without
groove with the hole of intermediate transfer belt unit frame and align the other end of groove on support
shaft with the hole of intermediate transfer belt unit frame.
7) Close the intermediate transfer belt unit and hook it to the support shaft to stand it.
< Work procedure 1-4>
8 / 12
Advertisement
