Table of Contents
Advertisement
10.Set Mode
10-4-4 BCLO (Busy Channel Lock Out)
This function is used on the main band and restricts transmission when another
signal is present on the same frequency.
1.Rotate the upper dial and select "BCLO".
"BCLO" will be displayed as shown on the
right.
2.Rotate the dial and select "on"-"off".
Iii
as
(ii}
223.500
BCLO
OFF
FM
When the Busy Channel Lock Out function is on, transmission will be allowed in
the following cases (1), (2) and (3), and you can only transmit under these
conditions:
(1)When a signal is not present
(2)When the tone squelch is active.
(3)When the DCS squelch function is active.
10-4-5 Tone-Burst
1.Rotate the upper dial and select "Tone-
burst''.
lil
8
s
@!I
"Tone-burst" will be displayed as shown on
the right.
223.500
Tone-burst
CALL
2.Rotate the lower dial and select the tone frequency.
By rotating the dial, the tone frequencies change as shown in the illustration.
FM
rDISABLE -
CALL -
1000 -1450 -
1750 -
2100
l
U. d' I
. H)
I
(
nits 1sp ayed
in
z
'---~~~~~~~~~~~~~~~~~~~~
III
79
Advertisement
Table of Contents
