10.Set Mode
10-4-3 TOT Penalty
This function sets the TOT penalty time that prevents transmitting for a specified
period of time after transmitting has been stopped by the TOT. The default is
OFF.
1.Rotate the upper dial and select "TOT
penalty".
"TOT penalty" will be displayed as shown on
the right.
BS~
145.000
TOT penalty
OFF
2.Rotate the lower dial and select the TOT penalty time from a range of
"OFF"<--> to "15 seconds".
Transmission will not occur during the time period designated in the TOT penalty.
If the [PIT] key is pressed during the TOT penalty period, a beep will sound.
10-4-4 BClO (Busy Channel lock Out)
This function is used on the main band and restricts transmission when another
signal is present on the same frequency.
2.Rotate the dial and select "on"<-->"off".
When the Busy Channel Lock Out function is on, transmission will be allowed in
the following cases (1), (2) and (3), and you can only transmit under these
conditions:
(1 )When a signal is not present
(2)When the tone squelch is active.
(3)When the DCS squelch function is active.
1.Rotate the upper dial and select "BCL.O".
"BClO" will be displayed as shown on the
right.
10-4-5 Tone-Burst
1.Rotate the upper dial and select "Tone-
burst".
''Tone-burst'' will be displayed as shown on
the right.
ItS~
145.000
BClO
OFF
85~
145.000
Tone-burst
CAll
80
2.Rotate the lower dial and select the tone frequency.
By rotating the dial, the tone frequencies change as shown in the illustration.
[
DISABLE -
CALL -
1000 -
1450 -
1750 -
2100
J
(Units displayed in Hz)