Table of Contents
Advertisement
10.Set Mode
( 10-5 REPEATER
)
The repeater access settings are explained in this section.
10-5-1 Auto Repeater Set
You can select whether or not the automatic repeater access setting operates.
There are two modes in this transceiver:
•On: The transceiver will automatically apply the shift direction and frequency
offset according to the standard repeater band-plans.
•Off: No offset occurs
1.Rotate the upper dial and select "REPEATER".
e:
s
&ii
"REPEATER" will be displayed as shown on the
right.
2.Rotate the dial and select "ON"+-+"OFF".
439.000
Auto rpt. set
OFF
'.
0
•Before operating while using the Auto repeater settings, please be
aware of local band plans.
CAUTION
The standard Auto-repeater band plans
Shift
222MHz 223.910 - 225.000MHz
-1.6MHz
902MHz 927.000 - 927.995MHz
-25MHz
•Shift direction and offset frequencies
A repeater normally retransmits a signal received on a certain frequency to
another frequency. The difference between these two frequencies is called the
offset frequency.
The range of the offset frequency may be set from
o
to 999.995MHz.
When using a repeater, when the [PTT] key is pressed, the transceiver shifts
from the received frequency, up or down, to the transmitted frequency monitored
by the repeater.
This change in frequency (up or down) is called the shift direction.
•
MEMO
·Please refer P.53/Tone encode or DCS to add tones. Manual
change of offset/shift is suspended within the standard repeater
frequencies when the auto repeater is activated.
81
Advertisement
Table of Contents
