Table of Contents
Advertisement
12.Cloning I PC Connection Functions
12.
Cloning I PC Connection Functions
The cloning function copies data from one DJ-G29T transceiver to another DJ-G29T
transceiver. Two DJ-G29T transceivers are connected by a cable and information
(including memory data) from the sending unit will be copied to the receiving unit
when using this function.
The DJ-G29T can also be connected to a PC and memory channels and/or the Set
mode settings can be edited using specialized software downloadable from Alinco's
web-site for free:
[_1_2_-_1_H_o_w~to~C_o_n_n_e_ct~~~~~~~~~~)
·When using the cloning function, an optional clone cable (EDS-11) will be
connected from the sender's earphone/microphone terminal to the receiver's
earphone/microphone terminal.
•When connecting this transceiver to a PC, an optional microphone/speaker plug
· conversion cable (EDS-10/14) is connected to the earphone/microphone terminal
of this transceiver and the plug of a PC connecting cable (ERW-7/ERW-4C) and
connected to the PC. See page 106 for details.
eclone cable (EDS-11)
Sender
Connecting to
the earphone terminal of
DJ-G29T
Clone communication terminal
Receiver
Connecting to
the earphone terminal
of
DJ-G29T
l
Ground terminal
l
i----~i
<:=CUii
(ID>=:>
( 12-2 How to enter clone mode
)
When sending and receiving clone data between DJ-G29T transceivers, or when
transferring data with a PC, follow these procedures:
1.Connect a clone cable (EDS-11) to the earphone/microphone terminal while
the transceiver is turned off, and then turn the transceiver on.
2.Press and hold the [MONI] key then press the [PTT] key 3 times. The
transceiver will be in the clone mode and is ready to transfer data.
(fl
99
Advertisement
Table of Contents
