84
10.Se!Mode
10-6-2 DTMF WAIT Time
When the auto dialer is sending DTMF tones, a tone will be sent after the WAIT
time setting. The default is
100
milliseconds.
1.Rotate the upper dial and select the
"DTMF WAIT time".
~
es(e]
"DTMF WAIT time" will be displayed as
shown on the right.
223.500
Wait timing
100ms.
'M
2.Rotate the lower dial and select the
DTMF
WAIT time in increments of 100
milliseconds ranging from 50 to 1,000 milliseconds.
When rotating the dial, the DTMF WAIT time will switch as follows;
[
50 -
100 -
200 -
• • • -
1000
J
(measurement value: milliseconds)
10-6-3 DTMF Burst Period for the First Number
When DTMF code is output by the auto dialer, the code output will start from the
burst period for the first number set.
1.Rotate the upper dial and select
"DTMF
1 ST".
"DTMF 1 ST" will switch through a range of
values from 20 ms to 2 seconds.
lilJ
sstii)
223.500
DTMF 1ST
100ms.
'M
2.Rotate the lower dial and select the burst period for the first DTMF
number.
When rotating the dial, the burst period will switch as follows
[20ms-40ms-60ms-80ms-1ooms-12oms-140ms-160ms-180ms-2ooms-· •
·-2s]