Table of Contents
Advertisement
iO.Set Mode
10-7-2 Tone SQ Priority Settings
When receiving in the dual band mode, tone squelch (TSQ) and DCS settings
will be valid on only one band. This parameter will allow you to select how
those features are applled.
1.Rotate the upper dial and select "Tone SQ
pri".
"Tone SQ pri" will be displayed as shown on
the right.
2.Rotate the lower dial and select the priority.
By rotating the dial, the priority will switch as shown.
[
Active band -
Main band -
Sub band
J
(ii
6
s
(iii
223.500
Tone SQ pri.
Active band
'M
Active band
The transceiver will give tone and DCS priority to the band that
is active.
Main band
The transceiver will give tone and DCS priority to the main
band. (It will give priority to the band indicated at the top of the
display)
Sub band
The transceiver will give tone and DCS priority to the sub
band. (It
will
give priority to the band indicated at the bottom of
the display)
10-7-3 DCS Operation Settings
There are cases when the squelch closes due to DCS settings and/or receiving
conditions.
In such conditions, you can change the DCS setting from normal to hold. This
operation allows opening the squelch by using a DCS code and closes the
squelch by normal squelch.
1.Rotate the upper dial and select "DCS
operation".
2.Rotate the lower dial and select between
"normal"++"Hold".
Iii
es (iii
223.500
DCS operation
Normal
'"
0
CAUTION
•When set to the keep position, in a case where the squelch opens
by acknowledging a DCS code, the squelch will remain open until all
transmissions on that frequency have concluded.
87
Advertisement
Table of Contents
