Table of Contents
Advertisement
38
6.0peration Mode
( 6-8 Tone Call Function
)
To use the Tone Call (Tone - burst) function:
•To transmit a tone, press the [MONI] key while pressing the [PTT] key.
•The default tone frequency is 1750Hz and can be changed in the Set mode (P.79
may be incorrect - please check.)
·When transmitting the tone, the CTCSS/DCS tones will halt temporarily.
[ 6-9 Repeater Function
)
Communications through a repeater are often possible with relatively low
transmission output.
By tuning the received frequency to a repeater
frequency, the Repeater function
operates automatically.
•Preset Repeater Frequeneies
222MHz:
223.910- 225.000MHz
-1.6MHz
902MHz:
927.000 - 927.995MHz
-25MHz
!ill
=·
' $
~
l.IFO
222.310
FM
l.IFO
927.000
Reverse operation is possible by pressing the
@JJ
key. The repeater function
releases temporary and you can transmit on the frequency originally used for the
repeater downlink while monitoring the uplink frequency. Press
@JJ
again to go
back to the normal repeater mode. The shift-direction icon flashes during the
reverse operation.
MEMO
·You may set the CTCSS tone, shift width and direction manually also.
Please refer page 53 for manual tone and page 61 for manual shift
setting.
Advertisement
Table of Contents
