Table of Contents
Advertisement
Ill
82
10.Set Mode
( 10-6 DTMF (Dual Tone Multi Frequency)
J
This setting applies to transmitting DTMF tones (the same sounds that can be
heard from the push buttons of an ordinary telephone). This function is used in
accessing certain repeater functions.
1.Select "DTMF" from the Set mode menu.
2.By pressing the dial, the sub menu will appear.
10·6-1 Auto-Dialer
This section explains how to register, transmit and record DTMF tones in the
memories.
Up to 16 characters can be input in one DTMF memory and 9 memory codes can
be registered.
•Setting the auto-dialer memory
1.Rotate the upper dial and select "DTMF",
and press down the main dial.
"DTMF" will be displayed as shown on the
right.
laJ
Gs~
223.500
F M
Auto-dialer 1
2.Rotate the lower sub dial and select the number of a dialer memory from
1
to 9.
3.Press the keypad and Input the DTMF
codes.
When you input the numbers, they will be
displayed as follows:
The numbers will be indicated as [
1 ]-+
[
12]-+[ 123]-+[
1234 ]-+[
12345]-+
[
123456]. Up to 16 numbers can be input.
Aut~-ffia~er
9
O O '"
123456789_
You can set the transceiver to pause instead of sending tones by pressing
the ~ key while inputting the code and then pressing the
m
key while
Ii
is
displayed.
When the transceiver is in the pause position, "-"will be displayed.
When the transceiver is set to pause, it will not transmit a signal for
approximately one second, corresponding with the pause position.
Press the
~
key and press the
@
key while
Ii
is displayed in order to
delete all of the DTMF codes that were input.
4.The input codes will be automatically recorded. The transceiver
will
return to the Operation mode by pressing the [PTT] key.
Advertisement
Table of Contents
