Table of Contents
Advertisement
6.0peration Mode
[ 6-7 Transmitting
J
Transmitting can only be done on the main band.
1. Tune a frequency in the selected band.
2.When the [PTT] key is pressed, the red light illuminates to indicate the
transceiver Is transmitting.
3.Speak in a normal volume approximately 5 centimeters away from the built·
in microphone on the front of the transceiver while pressing the [PTT] key.
4.Upon releasing the (PTT] key, transmitting will stop and the transceiver will
return to the receive mode.
0
CAUTION
•
MEMO
•When transmitting with the operating frequencies set in 222MHz -
222MHz or 902MHz - 902MHz bands, [RX disabled] will appear on
the display and reception will stop on the sub band temporarily.
·When the [MONI] key is pressed while the [PTT] key is pressed, a
Call Tone signal can be transmitted.
•When talking into the microphone, if your voice is too loud or you're
talking too close to the microphone, the modulation may be
distorted.
•Because the transceiver is manufactured to be water resistant, a special
cloth material covers the built-in microphone. For this reason, the
receiving station may hear transmitted voices slightly differently using
the built-in microphone in comparison to using an optional external
microphone. This is not a product malfunction.
•When the [PTT] key is pressed outside the transmission frequency
range, [TX disabled] will appear on the display and a beep will be
heard. Transmission cannot occur when this message is displayed.
•When transmitting while scanning on the sub band, scanning will
stop temporarily. After the transmission is finished, scanning will
start again.
•Operating the full-duplex without using an optioned earphone
microphone or an earphone may cause howling. Please refer P.80
"Full-Duplex" setting in the set-mode and select "prohibited" parameter
to avoid this.
·Please refer to P.107 "Specifications" for the details of frequency
range.
37
Advertisement
Table of Contents
