7
FUNCTION MENU SETUP
TX OFF SETUP
This function is to prohibit the transmission and to use the radio as a
receiver.
1.
Press and hold
key for over 2 seconds to enter setting menu.
FUNC
2.
Press
/
key to choose No.09 menu, LCD displays "TX-ON".
P3
P4
3.
Press
/
desired setting.
On:In current channel, press PTT to
transmit
OFF:In current channel, PTT is invalid.
4. Press any key except
Busy Channel Lockout
18
BCLO is to disable transmitting while receiving. Once the channel is busy
and you press PTT, the radio will beep as warning and holds transmitting
until receiving signal is gone.
1.
Press and hold
FUNC
seconds to enter setting menu.
2.
Press
/
key to choose No.10
P3
P4
menu, LCD displays "LOCK--OFF".
3.
Press
/
desired setting.
BU: Enable BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a carrier.
RL: Enable BTLO, transmitting is inhibited when current channel
receives a carrier but dis-matching CTCSS/DCS.
to select the
,
,
,
,
key to exit.
P3
P4
PWR
key for over 2
to select the
OFF: Busy channel lockout is disabled. It can transmit in any
receiving status.
4.
Press
key to confirm and exit.
P2
Editing Channel NAME
(Available only in Memory mode)
1.
In memory-mode, press and hold
for over 2 seconds to enter setting menu.
2.
Press
/
key to choose No.11
P3
P4
menu, LCD displays cursor and flashing.
3.
Press
/
to select the desired letter, press
to confirm selected letter and enter into next edition, press
return forward edition.
4.
After edition, press
key to exit.
FUNC
In Frequnecy display (VFO)mode, this menu is not available.
Reverse TX/RX
This function is used to check if you can talk without using a repeater.
TX frequency turns to RX frequency & RX frequency changes to TX
frequency. CTCSS/DCS setting is respected also.
1.
Press and hold
key for over 2 seconds to enter setting menu.
FUNC
2.
Press
/
key to choose No.12
P3
P4
menu, LCD displays "REV—OF".
3.
Press
/
desired setting.
ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse.
4.
Press any key except
PWR
key
FUNC
to select the
,
,
,
,
key to exit.
P3
P4
key
P2
to
P1