Table of Contents
Advertisement
104
14.Maintenance and Reference
Symptom
Possible Cause
Action
Repeater-Access Incorrect setting of parameters.
Confirm the repeater settings.
can't be used.
Can't transmit.
Battery is exhausted.
Replace or charge the battery
pack.
Display flashes
Not pressing the PTT key Press the
PTT
key and
or goes out when firmly enough.
confirm that the TX/RX
you transmit.
lamp is lit red.
The transceiver will not transmit Transmit within the range of
out of the authorized band. authorized
frequencies.
(The shift setting is incorrect.)
Confirm the repeater settings.
The frequency is incorrect.
Properly adjust the frequency
at the other station.
The display
Battery is exhausted.
Replace or charge the battery
flashes or
pack.
disappears
during reception.
·Waterproof portions such as DC power supply jack caps are consumable items
that must be replaced from time to time.
•If after-sales service or support is necessary, please contact the dealer you
purchased this transceiver from. To locate your nearest dealer, please read the
"US/CANADA DEALERS" in the "DISTRIBUTION" menu of our website
(http://alinco.com/usa.html).
·An update of firmware maybe available for this product and the detail is posted
on our website. For this reason, Your DJ-G29T may operate slighty different
from the explanations given in this manual after such update is performed.
•Jn case of requesting technical assistances over the phone to your local Alinco
dealer, we recommend you to indentify the version of firmware in advance as
follows:
1 :Press and hold
~
key for 2 seconds to lock the keys.
2:Press
~
key 1 O times consecutive. Copy the numbers that appars on the
display.
3:Press PTT to return to the operating mode.
Advertisement
Table of Contents
