Table of Contents
Advertisement
90
10.Set Mode
10-9-1 Scan Mode Settings
You can set the conditions under which scanning will resume after stopping for a
monitored signal.
1.Rotate the upper dial and select "Scan
mode".
rm
BS
4i!l
223.500
"Scan mode" will be displayed as shown on
the right.
Scan mode
BUSY SCAN
FM
2.Rotate the lower dial and select from "BUSY SCAN"+-> "1 second timer" to
"25 seconds timer"+->"1 second elapse" to "5 minutes elapse".
Set the scan mode according to the table below.
Busy scan mode
Scanning will resume if there is no signal after stopping the
scan.
Timer scan mode Scanning will resume when the selected time is up even
when receiving a transmission.
Elapsed Time
This function will resume scanning when the selected time
setting scan mode is up regardless of whether or not there is a signal. This
MEMO
function will operate even when the squelch is open. The
time to stop scanning can be set from 5 seconds to 5
minutes.
•The time setting scan mode automatically moves to the next channel
when the set time is up regardless of whether or not there is a signal.
As this mode operates even when the squelch is open, it is a useful
function when scanning data communications.
·This function can be used in the VFO mode, the Program scan mode
and the Memory mode.
Advertisement
Table of Contents
