Tot (Time Out Timer); Tot Penalty - Alinco DJ-G29T Instruction Manual

78
10.Set Mode
10-4-2 TOT (Time Out Timer)
This function automatically stops transmission if it continues beyond a specified
time.
eTOT Setting
1.Rotate the upper dial and select "TOT."
"TOT" will be displayed as shown on the
right.
Iii es~
TOT
OFF
223.500
'
"
2.Rotate the lower dial and select the desired TOT from a range of "OFF"
++
from "30 seconds" to "450 seconds".
When the dial is rotated, TOT will switch in the increments shown in the
illustration.
(time shown in seconds)
[OFF-so-so-oo-120-1so-1ao-210-240-27o-soo-330-3so-3l)3-420-4so]
•
MEMO
•Just before the time exceeds the specified limit, a beep will sound
and the transceiver will switch to the receive mode. When this
occurs, you must release the [PTT] and press it again to resume
transmitting.
·When a TOT penalty time is set, you can't transmit by pressing
the [PTT] key until the specified penalty time has elapsed. Please
refer to "TOT Penalty (P.78)" to set the TOT penalty time.
10-4-3 TOT Penalty
This function sets the TOT penalty time that prevents transmitting for a specified
period of time after transmitting has been stopped by the TOT. The default is
OFF.
1.Rotate the upper dial and select "TOT
penalty".
"TOT penalty" will be displayed as shown on
the right.
Iii]
a s
(ii]
223.500
TOT penalty
OFF
'"
2.Rotate the lower dial and select the TOT penalty time from a range of
"OFF"+-+from "1 second" to "15 seconds".
Transmission will not occur during the time period designated in the TOT penalty.
If the [PTI] key is pressed during the TOT penalty period, a beep will sound.