Table of Contents
Advertisement
100
12.Cloning I PC Connection Functions
When the transfer of data to another DJ-G29T transceiver is complete, the power
automatically turns off and then turns on again.
0
CAUTION
•When transferring data, do not press any keys.
·When transferring data, do not disconnect the cables. If a cable
disconnects, [ERROR] will be shown on the display of the sending
transceiver and data transfer will stop.
•When using the cloning function, data in the receiving unit will be
completely replaced with data of the sender. Please be careful when
there is already data stored in the receiving radio.
( 12-3 Transferring Date
)
1.With the transceiver turned off, connect a clone cable (EDS-11) to the
earphone/microphone terminal of the unit that will receive data and then
turn the transceiver on.
2.Press and hold the [MONI] key and press
the [PTT] key 3 times on both radios.
"CLONE" will be displayed as shown in the
right.
3.By pressing the dial on Master radio, data
will be transferred to the slave radio.
CLONE 57600dps
4.When the transfer is finished, "FINISHED!" will be displayed.
If "ERROR" is displayed, redo from step 1.
5.Turn the power off to cancel the clone mode.
If the power supply is not turned off, the clone mode will not be released.
Advertisement
Table of Contents
