Table of Contents
Advertisement
76
10.Set Mode
10-3-2 Pager
1.Rotate the upper dial and select "Pager".
"Pager" will be displayed as shown on the
right.
liJ
B S
(i!I
223.500
Pager
OFF
FM
2.Rotate the lower dial and select from either "OFF", "Main band only" "Sub
band only" or "Either band".
When the pager is set,
Ji
appears on the display.
When the transceiver receives a signal,
Ji
blinks and a bell sounds.
Ji
blinks
until the next operation occurs. This function can be used as confirmation of an
incoming signal if you are not in proximity to the transceiver at the time it is
received.
OFF
The bell will not sound.
When received
The bell will sound when a signal is received on the main
on the main band
band.
When received
The bell will sound when a signal is received on the sub
on the sub band
band.
When received
The bell will sound when a signal is received on either
on either band
band.
10-3-3 End-Beep
This function informs you, and those listening to your transmitted signal, that you
have ended your transmission by sounding a short beep that is heard when you
release the PTT.
1.Rotate the upper dial and select "End-
beep".
"End-beep" will be displayed as shown on the
right.
2.Rotate the lower dial and select "OFF"
+-+
"ON".
~
"4iil
223.500
End-beep
OFF
F M
Advertisement
Table of Contents
