Partial Reset - Alinco DJ-G29T Instruction Manual

222/902mhz dual band fm transceiver
Hide thumbs Also See for DJ-G29T:
Table of Contents

Advertisement

2
NOTICE I Compliance Information Statement
NOTICE
I
Compliance Information Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used
in
accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the receiving antenna .
. ·Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
transceiver is connected.
•Consult the dealer or an experienced radiorrv technician for help.
Tested to Comply
With FCC Standards
FOR HOME OR OFFICE USE
Information in this document is subject to change without notice
or
obligation. All
brand names and trademarks are the property of their respective owners. Alinco
cannot be liable for pictorial or typographical inaccuracies. Some parts, options
and/or accessories are unavailable in certain areas. Changes
or
modifications not
expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
222!902MHz FM amateur radio handheld transceiver DJ-G29T
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Manufacturer:
ALINCO,lnc. Electronics Division
Yodoyabashi Dai Bldg 13F, 4-4-9, Koraibashi, Chuo-ku, Osaka 541-0043 JAPAN

Advertisement

Table of Contents
loading

Table of Contents