Table of Contents
Advertisement
10.Set Mode
[ 10-2 POWER
&
BATT.
)
Power supply settings are explained in this section.
1.Select "POWER & BATT" from the Set mode menu.
2.By pressing the dial, the sub menu will appear.
10-2-1 Auto-Power-Off
When active, if the transceiver has not been operated during the set-time, a beep
will sound and the transceiver will automatically turns off.
1.Rotate the upper dial and select "Auto·
power-off".
"Auto-power-off" will be displayed as shown
on the right.
e:i Iii
" 4iil
223.500
Auto-power-off
30 minutes
'M
2.Rotate the lower dial and select the amount of time before the transceiver
shuts down.
When rotating the dial, the Auto-power-off setting changes as shown in the
illustration.
[
Off -
30 minutes -
1 hour -
2 hours -
3 hours -
5 hours -
8 hours
J
To turn the transceiver back on, press the power switch again.
•
MEMO
·The APO (auto-power-off) time counter will not be extended by
simply receiving signals, but will reset after key operations have
been performed.
10-2-2 BS {Battery Save) ratio
This function controls battery power consumption and extends battery life
between charges by turning the transceiver's internal power on and off for brief
periods.
1.Rotate the upper dial and select "BS
ratio".
"BS ratio" will be displayed as shown on the
right.
Iii
• •4iil
223.500
f M
BS ratio
0. 2 : 0. 8
~N ~~~~~~
Time OFF
III
73
Advertisement
Table of Contents
