Table of Contents
Advertisement
80
10.SetMode
10-4-6 PTT delay
This is to cut the squelch tail noise that the repeater retransmits at the end of
receiving tone-encoded CTCSS signals.
1.Rotate the upper dial and select "PTT delay"
"PTT delay" will be displayed as shown on the
right.
~
&$~
223.500
PTT delay
0.6
2.Rotate the lower dial and select the desired PTT delay time.
By rotating the dial, the PTT delay time changes as shown in the illustration.
r
OFF -
0.3 -
0.6 -
1
l
!~---------------~
(unit: seconds)
10-4-7 Full-Duplex Setting
FM
In order to avoid entering receiving sound of sub-band that may cause an
interference to the main-band transmission, the sub-band receive can be muted
while transmitting on the main side.
1.Rotate the upper main dial to select "Full-
duplex" as shown.
Iii
e s
(iii
223.500
Full-duplex
Permitted
2.Rotate the lower main dial to select "Permitted"<--> "Prohibited".
FM
Advertisement
Table of Contents
