Match Ipv6 Address - Planet SGS-6341 Series Command Manual

31.8 match ipv6 address

Command:
match ipv6 address <ipv6-acl-name | prefix-list list-name>
no match ipv6 address [<ipv6-acl-name | prefix-list list-name>]
Function:
Configure the prefix for ipv6 routing. If the no form command is enaled, the configuration will be
removed.
Parameters:
address is the routing prefix to be matched. <ipv6-acl-name> is the name of ipv6 access list. Or
when the prefix-list is configured. list-name will be the list name to be matched.
Command Mode:
route map mode
Usage Guide:
When this command is enabled, the prefix-list in the routing table will be used for routing decision.
And if matched, the permit deny operation in the route map will be executed.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match ipv6 address prefix-list mylist
31.9 match ipv6 next-hop
Command:
match ipv6 next-hop <ipv6-address>
no match ipv6 next-hop [<ipv6-address>]
Function:
Configure the next hop for ipv6 routing. The no form command will disable the configuration.
Parameters:
next-hop is the next station for routing. ipv6-address is the ipv6 address for the ip address of the
interface on the next station.
Command Mode:
route map mode
Usage Guide:
If this command is configured, packets will be delivered according to the next hop information in the
routing table. If matched, the permit or deny operation in the route map will be executed.
31-117